Why does it need to start at the workbench level instead of the top of the piece to be cut? I have always set the x and y where I want it to start and the z on the top of the piece to be cut. The I zero it out by picking set home offsets on the display when using an SD card or disconnecting and reconnecting in repetier host when using that to send…[Read more]
I built mine 36×36 and have just barely 24×24 cutting area. I would recommend making it slightly bigger than 36×36 if you are going for 24×24 work area. I used the wire harness from the shop and with that harness plus the wire from the motors I have a ton of extra so I don’t think you will have a problem.
- Load More