Z steppers series?

New Home Forum LowRider Advice – LowRider Z steppers series?

This topic contains 2 replies, has 3 voices, and was last updated by  Jeffeb3 6 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #88794

    Ed Roberts
    Participant

    The Rambo mini has 2 drivers for the Z axis.  Should that be run in series like the Y axis?  If so does it matter which Z port to use?

     

    Thanks,

     

    Ed

    #88808

    Aaron
    Participant

    I believe there is still only one driver for the Z, but just 2 ports you can plug them into, I forgot if they are in parallel or series.

    2 users thanked author for this post.
    #88817

    Jeffeb3
    Participant

    The onboard connectors are going to the same driver and are wired in parallel. You should make a series wiring harness and connect it to either one. It does not matter which.

    2 users thanked author for this post.
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.