Y bed improvement

This topic contains 3 replies, has 3 voices, and was last updated by  Bill 9 months, 2 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
  • #33631


    Hey guys

    Ive been running the mp3dp for a few weeks now. Im using zip ties on the lm8uu bearings on the y axis bed. Theres a little play/wobble that i think might be affecting the quality of my prints (vibrations maybe). Any suggestions to make the bed a little stiffer?


    David LaRochelle

    Print three of these and install in existing holes, they match perfectly.
    Use m3 machine screws and nuts.
    No more wobble!

    1 user thanked author for this post.


    Awesome! Appreciate the link! I think this will help a lot!



    I modded mine by changing to four linear bearings in a rectangle instead of three in a triangle. The Y is so much smoother and no longer has the wiggle it had before. Before I did that I tested some graphite impregnated brass bushings, but they introduced too much drag, the belt would skip.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.