X + Dual Y Endstops + Z Probe – for Lowrider V2

New Home Forum LowRider Hardware Development – LowRider X + Dual Y Endstops + Z Probe – for Lowrider V2

This topic contains 2 replies, has 2 voices, and was last updated by  Greg 3 weeks, 5 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #93788

    Greg
    Participant

    I got my X, dual Y and Z probe stops working for the lowrider V2.

    Don’t attempt unless you are comfortable modifying firmware files.

    https://www.thingiverse.com/Tailslide/collections/low-rider-cnc-v2

    The result is, I can draw a 300mm square with my lowrider, turn it off, move the carriage, fire it back up and rehome, and draw a second square and it is entirely repeatable to the width of my pen I can’t see any difference at all. Also the square is completely square as far as I can measure.

    2 users thanked author for this post.
    #118305

    Paul Oberhoff
    Participant

    Hey Greg,

    what dit you change in the firmware.? I downloaded the dual endstop firmware but it is for the mpcnc- with 2 steppers per horizontal axes and 1 stepper on the z axe.

    what schould I change for the lowrider with 2 Z-steppers.?
    sry English is not my nativ language .

    thx for help.

    #118346

    Greg
    Participant

    Hi Paul there is a link to a copy of the firmware I use in the description of my thing here https://www.thingiverse.com/thing:3504113

    You don’t need the servo and z probe to run this firmware but you do need Rambo mini with dual Y end stops and an x endstop wired. If you need to home without a Z endstop you have to do it with G28 x y

    All changes I made to the firmware are commented with the Initials FSIGAP

    Greg

     

     

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.