wiring Stepper to board

This topic contains 5 replies, has 3 voices, and was last updated by  Manolo Suarez 2 weeks ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #111511

    Manolo Suarez
    Participant

    Hi, the stepper motors that I own have no connector, so cables are loose and I am afraid to connect them wrongly, any help is more than welcome.

    Parts:

    1-Nema 17 3D printer stepper motor CNC stepper motor 78 Oz-in/48mm stepping motor/1.8A.

    2- MKS Gen V1.4 Control board RepRap Mega 2560 R3 Motherboard Ramps 1.4 with USB.

    3- cables color are in the picture below:)

     

     

    #111718

    Chris
    Participant

    look on google images, it shows black green, red blue.

    1 user thanked author for this post.
    #111831

    Barry
    Participant

    You may have to move a pin here and there after installing the ends.  Color order isn’t a standard.

    1 user thanked author for this post.
    #112459

    Manolo Suarez
    Participant

    I am afraid to burn the steppers or the board

     

     

    #112521

    Barry
    Participant

    Wiring a stepper wrong won’t hurt the board or stepper, it just won’t move.  Start with that wiring order, just keep in mind you might need to change a couple.

    1 user thanked author for this post.
    #112543

    Manolo Suarez
    Participant

    that was an important information, thank you very much Barry.

     

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.