WIP

Tagged: , ,

This topic contains 3 replies, has 2 voices, and was last updated by  ZRHERBERT 2 years, 1 month ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #17605

    ZRHERBERT
    Participant

    Work In Progress.

    I only have the XYZ pieces left to print. My modified Printrbot has done well but is still a little small for these two. I’m hoping to cut the models and reprint once my build is complete. Aiming for a 24″ x 24″ x 10″ build volume.

    Purchased kit has been really easy to assemble with my printed parts so far.

    #17656

    Fred D PInczuk
    Participant

    Where are you located? I can possibly help you out to print the center parts.

    #17681

    ZRHERBERT
    Participant

    Thanks for the offer. I’m in the Pittsburgh area (15237). Looks like you are a little far away from your pictures and we would have to snail mail each other.

    I’m just hoping the “cut” XYZ will hold together enough to print out a new set. I also only printed at 20% infill to speed things up and I am anticipating the need to re-print piece as they fail. I’m going to start out using it as a 3D printer only.

    My Christmas list includes the DeWalt router, so maybe I’ll start machining in the new year!

    #45689

    ZRHERBERT
    Participant

    Whew… a year later and I have made some progress. I’ve been putting this offer as I work full time, handle a 3 year old son, and go back to school. Finally put my foot down and stayed up til 2am to get this far. I was tired of the partially assembled parts laying around. Still needs belts and a full base (hence the extra length of pipe extending out) but this should get done in the next week or two.

     

     

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.