Wheels are at an angle problem  

New Home Forum LowRider Troubleshooting – LowRider Wheels are at an angle problem  

Tagged: 

This topic contains 4 replies, has 3 voices, and was last updated by  Dennis 2 months, 1 week ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #100049

    Dennis
    Participant

    I had the problem that my wheels were tilted. I started to measure everything and in my case the y plate was too large for the 25 mm model. I adjusted the drawing and made new y plates and now my wheels are straight.

    In the attachment is the modified drawing of the y plates for 25mm model

    #100053

    Jeffeb3
    Participant

    You can either zip up .dxf or rename it .txt.

    1 user thanked author for this post.
    #100077

    Ryan
    Keymaster

    What dimension did you change? Your center axis is not perpendicular/horizontal.

    #100176

    Dennis
    Participant

    I only made it narrower -4mm
     

    #100182

    Dennis
    Participant

    yes it is correct that it is tilted. I had not seen that in inkscape. I’m not very good at cad drawing, everything is new to me

    but my wheels are now straight and I have the lowrider perfectly aligned and squared

    I used the drawing as a paper mold and sawed it out with a jigsaw. once I have installed my router I check the drawing again and I will mill it.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.