Warm Stepper Motors

This topic contains 1 reply, has 2 voices, and was last updated by  Barry 1 month ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #109956

    Ryan
    Participant

    Ok, after printing the crown, I went back and taped all the wires, put them in wire loom and got everything set a little more permanent.

    I have the dual end stops and haven’t messed very much with the coding at all. The stepper motors are warm and I have only been moving the axis to make sure the wiring is all OK with the lengths and that the “tapemeasure trick” works fine. I can still put my hand on the motors, but they are pretty warm. What could be some of the causes?

    #109961

    Barry
    Participant

    Steppers get warm.  If you can’t hold onto them, then they’re too hot, other than that, don’t worry about it too much.

    2 users thanked author for this post.
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.