Vcarve question

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 6 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #44552


    I’m just starting to play with an v groove bit,  and v carve in in estlcam. I am getting rounded edges were it should be square.  I am guessing I programmed they bit incorrectly.

    Any suggestions?



    Looks like your bit angle is wrong, too large I believe. I think a common thing is divide by two, some say the total angle some say the chamfer angle if I am not mistaken.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Pin It on Pinterest