U.Washington/Open3DP fabs 20 MP3DPs

New Home Forum Milled Printed 3D Printer -MP3DP Your Builds – MP3DP U.Washington/Open3DP fabs 20 MP3DPs

This topic contains 2 replies, has 3 voices, and was last updated by  Bill 9 months, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #78444

    mark
    Participant

    We just ran a team build event to fabricate 20 (yes twenty) V1Engineering’s MP3DP 3D printers. Shown the printer by AugustHonnell, Leo Orozco and Szymon Saranowicz was the first to produce results. So awesome.  We made modifications (as always) to use a standard rod length of 12″ (costs $1.30-ish each at McMaster) which resulted in a slightly smaller printer.    We promise we will share all modifications with V1 and all of you on Thingiverse.   All in all, this was a great build.  Thanks again Ryan!!!

    #78448

    Jeffeb3
    Participant

    20? Why not 40?

    Seriously, this is awesome! Thank you for sharing.

    #78798

    Bill
    Participant

    And not a bad Benchy in progress there! 🙂

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.