Tubing and Board Questions

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Tubing and Board Questions

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 1 week, 6 days ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #112871

    Chaosmachine420
    Participant

    I am making sure if it would be better to use the structural/plumbing pipe that is painted black. I only ask because the emt at Home Depot is not that smooth at all. I would like to know is the Archim board good to have turn on and control the speed of the spindle and height with a z probe or is there something better that can do all that?

    #112884

    Ryan
    Keymaster

    The EMT is better for a few reasons, if it seems really rough the zinc usually wears off really fast, or you can sand it.

    All the boards are the same in that respect. All can Z probe, none can directly control spindle speed with out added parts.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.