Top corner doesn't touch the bottom corner part

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Top corner doesn't touch the bottom corner part

This topic contains 1 reply, has 2 voices, and was last updated by  Barry 1 week, 4 days ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #117055

    Kamil
    Participant

    I’m building my Base now, after i put the tubes and put the top corner parts i see a big gap between it and the bottom corner part, is that normal?

    shouldn’t they touch?

     

    #117077

    Barry
    Participant

    It’s not supposed to.  It’s a clamp.  Don’t go crazy tightening it.  Just snug enough to keep the tubes from moving.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.