Tinkercad FingerJoint Help

New Home Forum Random or Off Topic Tinkercad FingerJoint Help

This topic contains 0 replies, has 1 voice, and was last updated by  James 2 weeks, 1 day ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #119317

    James
    Participant

    Hey guys.

    I’ve been kicking around the idea of a mobile stand for the laptop in the shop. I can leave everything connected and just move the entire thing.

    Anyway, my mpcnc is 24″x36″ so I was thinking of just using finger joints halfway up and on the outside corners to make it a little sturdier. I have been googling how to set them up for 2 days without much info. I will link the idea I have and if someone has any input I would appreciate it. I was using Tinkercad because I have access to it at work but also have Fusion360 if that would be better for this application.

    The stand is dimensioned to fit over a 12″x18″ mover’s dolly so I can just slide it over and run some screws in.

    Any input would be great guys.

     

    Thanks,

    James

     

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.