Theory question

This topic contains 2 replies, has 3 voices, and was last updated by  Jeffeb3 2 months, 1 week ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #49530

    Chuck Pickering
    Participant

    Situation: Z height decreases as a program is run. Possible causes? Z steps/mm is too large? Too small? Z axis is binding in + direction?

    #49534

    Ryan
    Keymaster

    Usually the rapid speeds where set incorrectly or not at all and the processor is just not moving the axis because the number of steps is too high.

     

    Without a lot more info we can’t help. Board, Steps, drivers, speed, rapids, cam program?

    #49535

    Jeffeb3
    Participant

    Can you explain that a bit more?

    Is it lowering as time increases? Raising?

    Is it lowering as it moves in one particular direction? (((Like, is it lower on the right than left)))

    Does it lower only when doing cutting? Can you move it down by some amount and then back up?

    Maybe a picture of the job you’re doing will give us more clues.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.