The Carver's MP3DP

This topic contains 242 replies, has 17 voices, and was last updated by  Jeffeb3 2 months, 1 week ago.

Viewing 3 posts - 241 through 243 (of 243 total)
  • Author
    Posts
  • #99671

    Jeffeb3
    Participant

    Do you have the software you flashed last time saved somewhere?

    You can get some of the settings from the serial port. Pronterface prints them all, I think It’s M50X, but I cant remember which one.

    I haven’t done manual, electronic bed levelling. So I can’t help you there.

    #99673

    Kelly D
    Participant

    Do you have the software you flashed last time saved somewhere?

    I’m quite certain I don’t – didn’t know that much back then ; ) I definitely recall last time that I had to download the Rambo/Aero version AND the Ramps/Mk8 version and cross reference all the way through because at the time there wasn’t a mRambo/MK8 version on github. (Does that sound right? I’m pretty sure that was the situation.)

    Actually, I think in this thread there was a posting of my Config for troubleshooting…so perhaps not “quite” right but posted nonetheless. I’ll have a sift back through. Not terribly worried mind you – this flashing stuff is a breeze for this cat! Hahahaha

    I’ve heard Pronterface referenced many (many) times on this forum but never asked what it was or looked into it. I should do that too…..

    #99696

    Jeffeb3
    Participant

    Pronterface is like repetier host. I don’t know why, but I like it better.

Viewing 3 posts - 241 through 243 (of 243 total)

You must be logged in to reply to this topic.