Tabletop pcb router

New Home Forum Random or Off Topic Tabletop pcb router

This topic contains 2 replies, has 3 voices, and was last updated by  Jeffeb3 11 months, 4 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #30414


    So, I’ve been wondering.. if I put a dremel on an mp3dp and flash the Cnc firmware to it, can I make it work as a tabletop pcb router?

    I’d think that aside from maybe stiffness of the middle being a possible issue with a big dremel instead of a small extruder it should work, right?

    Maybe then design a new center part that doesn’t snap together and mount the dremel there…




    Slap on a flex shaft instead like we used to, keep it as straight (non bent) as possible to minimize load and overheating of the shaft. It would be cool. There was a MP3DP with a laser attachment at MRRF.



    The firmware will be a hybrid of the two. You’ll have to turn off the temp/extruder stuff of the MP3DP firmware, or adjust the steps/mm on the CNC firmware.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.

Pin It on Pinterest