Table ++

New Home Forum Things You Have Made Table ++

This topic contains 1 reply, has 2 voices, and was last updated by  Bill 2 years, 5 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #32453


    Not built (yet) but I’ve drawn a table in onshape based on these awesome (although expensive) tables:

    OnShape CAD drawing

    I tried to make the design well parameterized, and it expands to the size of your table (mine is currently 32x48in). You’d need 2 cuts of each part, except the stretchers. It’s most similar to the ++ version of the table.

    I also made layers for test pieces, which should help get the thicknesses and stuff right before you cut a huge amount of ply. I haven’t even tested this part of it.

    And I made a layer with locations for holes, which I will use to cut some 2mm deep holes to use as clamps, and I’ll use them to make sure the z height is good enough across the entire cutting area. It’s not loading into estlCAM, I think it’s because there’s no geometry, so I need to fix that.

    I thought I would post this in case someone had some ideas or thoughts before I try to make it. Has anyone tried to cut through laminate? I think I should attach some laminate to the ply before cutting. I’ve never done laminate, but I’ve seen it on youtube 🙂 .


    ((( BTW, I called it Trains+ because I’m planning on making it for my toddler to play with his wooden trains ))).



    I’ve cut some designs into laminate flooring pieces without issues.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.