SWMN Build

This topic contains 3 replies, has 3 voices, and was last updated by  Michael 2 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #91699

    Michael
    Participant

    My only regret is that there were not more parts to put together. Everything fit together so well I couldn’t put it together wrong if I tried(and believe me I tried several times). I have not had that much fun putting something together in a long time. So thank you Ryan.

     

    I put my MPCNC together in my kitchen as the -15 degree weather was a little to cold for even my MN blood to handle out in the garage. The picture I have of it are with the wires unhooked and sitting on the basement floor(Pics or it didn’t happen right?). I also printed out the crown using Ryan’s provided gcode on the build page. I do think I have something messed up somewhere and I think it could be with the belts maybe? The lines, especially the curved ones, are kinda stair steppy. Any Ideas?

     

    EDIT: Also the whole think kinda ‘vibrates’ when it moves… Maybe this is only because the table could be shaky?

    1 user thanked author for this post.
    #91727

    Jason
    Participant

    Looks good

    #91748

    Ryan
    Keymaster

    Hard to say really, once you screw it down and try again on a smooth surface it will probably be great!

    #97442

    Michael
    Participant

    My spoil board is not level at all so there is a lot of depth variation but on the whole for a second try I think it turned out OK. I got a bit from a big box store that I am going to try to use to flatten everything out. Other than that the machine worked beautiful!

     

    EDIT: Also you were right Ryan. After bolting the machine down all the little wiggles stopped! Thanks again for such an amazing piece of hardware!

    • This reply was modified 2 months ago by  Michael.
    1 user thanked author for this post.
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.