Stopping and resuming jobs.

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Stopping and resuming jobs.

This topic contains 2 replies, has 3 voices, and was last updated by  Ryan 4 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #103480

    Jeff
    Participant

    I work a job that has be on call, and sometime have to leave the house for hours at a time. I was wondering if there is a way to stop a job, power down the MPCNC and start it up again when I get home. I primarily use the LCD and SD card for all jobs. Would I have to run the jobs through repeater to have this functionality?

    #103481

    Mike Atencio
    Participant

    Excellent question! Like trying to remake my waste board and had to start over!

     

    #103499

    Ryan
    Keymaster

    Not with extreme accuracy, dual endstops would be required on at least one axis depending on what dimensions were most important.

    If you are just making non critical things and stop between paths you should be able to get it reasonably close if you are careful with your gcode.

    1 user thanked author for this post.
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.