Stepper Series Wiring

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Stepper Series Wiring

This topic contains 4 replies, has 4 voices, and was last updated by  Robin Morgan 2 months, 1 week ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #105637

    Robin Morgan
    Participant

    is there anywhere you can buy the stepper series cables this side of the pond, again ordering from the states is too expensive for shipping OR

    is the below acceptable solution as I have all the bits required

    https://www.instructables.com/id/Wiring-Your-Z-Stepper-Motors-in-Series/

    #105659

    Barry
    Participant

    Both my machines are wired with cat-5 patch cables.

    This is from the stepper port on the board.  The stepper side is wired red to orange, green to green, black to brown, and blue to blue for B keystone pinout.  You should check the pairs though, there isn’t a color standard, but that’s probably correct.

    1 user thanked author for this post.
    #105663

    Erwin Vigilia
    Participant

    Either method will work (the one you linked, or the CAT-5 RJ Barry shared)

    1 user thanked author for this post.
    #105718

    Ryan
    Keymaster

    As far as I know it is DIY or me. I have them custom made as I could not find any, anywhere.

    1 user thanked author for this post.
    #105756

    Robin Morgan
    Participant

    Hadn’t got as far as the wiring in the build guide, should of checked first before posting

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.