Stepper moving erraticly

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Stepper moving erraticly

This topic contains 2 replies, has 2 voices, and was last updated by  Bill 1 month ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #110118

    Ryan
    Participant

    I started having a weird issue with one of my X stepper motors. When i move it in either direction, it starts by moving a few mm in the opposite direction before moving the way I sent. Has anyone ever experienced that?

    If I send +50mm it will go a few mm in the negative direction, then go the +50mm

    #110119

    Ryan
    Participant

    Well checked the wiring and it was the connection between the stepper and the long piece of wire I had it connected to. Green wire had come out.

    1 user thanked author for this post.
    #110410

    Bill
    Participant

    And all in an hour and 14 minutes. You can officially say you are getting good at this… 🙂

    1 user thanked author for this post.
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.