Starting build, having trouble I think

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC Starting build, having trouble I think

This topic contains 3 replies, has 2 voices, and was last updated by  Ryan 4 months, 3 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #94798

    hank hogan
    Participant

    When putting together the middle section it doesn’t quite fit together properly, there are fairly big gaps between the top & middle parts where the 2.5 ” bolts go..

    Is this normal or wrong ?

    #94802

    Ryan
    Keymaster

    You really need to show the complete assembly. Those pictures don’t show enough to help.

    Make sure every bolt and bearing is in, including the entire z axis.

    #94885

    hank hogan
    Participant

    I figured it out, my parts are printing larger then they are supposed to be . Can’t figure out why.

    #95113

    Ryan
    Keymaster

    Print A calibration cube and you will probably need to adjust the steps per mm in the firmware on your printer.

     

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.