Start Mill Point.

Tagged: 

This topic contains 4 replies, has 3 voices, and was last updated by  Ryan 3 weeks, 4 days ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #118354

    Manolo Suarez
    Participant

    Hello,

    The machine is ready, Dual Endstop the test was the crown.

    First I Home X & Y, then printed, when finished I home X & Y and print again to check if it is  drawing in the same position.

    By the picture it is not.

    What I am missing?

    Attachments:
    #118356

    Jeffeb3
    Participant

    Ryan’s gcode has a G92 in it. Did you move the machine after home either time?

    1 user thanked author for this post.
    #118357

    Manolo Suarez
    Participant

    Hi Jeffeb3, I home before each draw. but I did not turn off the machine.

    #118362

    Jeffeb3
    Participant

    If you did:

    Home

    Some jogging

    Start gcode

    It would be different if the jogging was different for the two tries. Even if you leave your machine on.

    1 user thanked author for this post.
    #118414

    Ryan
    Keymaster

    Change the G92 line to G28 X Y, then you will need to figure out the Z as well…My Crown is not a test of the Dual endstops without a lot of work.

    1 user thanked author for this post.
Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.