Spring loading the Z Axis

New Home Forum LowRider Hardware Development – LowRider Spring loading the Z Axis

This topic contains 1 reply, has 2 voices, and was last updated by  Jeffeb3 6 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #44226


    Hey there,


    i was just wondering, if the Z Axis lowering could be prevented by springloading it?

    Would there be any negative downsides of doing so?


    If i need to hit the emergency switch, the Z Axis comes down so fast, that the spinning bit ruins the workpiece almost every time (Happy that i need to press it not that often :D)


    …was just wondering



    Springs don’t apply a constant force. They apply a force proportional to the distance to their resting position. That would make them tough to use in this situation, especially if you were trying to make them push up from the carriage.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.

Pin It on Pinterest