Shitty board?

New Home Forum LowRider Troubleshooting – LowRider Shitty board?

Tagged: ,

This topic contains 5 replies, has 5 voices, and was last updated by  David Walling 3 weeks, 5 days ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #115108

    Jake
    Participant

    Need some help troubleshooting if I have a shitty board.

    Here’s the board I bought

    Here’s what my LCD screen looks like when I fire up

    Attached a pic of what the screen looks like during use.

    As far as my build goes, I’m super satisfied: printed the parts, bought the kit from V1, built a nice little bed, everything is wired and initial tests show me it’s working great… however, this faulty display issue makes the machine hard to manage and move on to carving stuff up!

    Side note: when I bought my Lowrider kit, I accidentally had two of these LCD monitors in my cart. Ended up coming in handy though since I have used both screens to test and verify they both display weird, leading me to think it’s my board. I used the pre-configured firmware as recommended.

    Thanks in advance to anyone willing to chime in and take the time to help a brother out!

    #115111

    Jeffeb3
    Participant

    Is the language set to klingon?

    I’ve seen this before, but I can’t remember when… Maybe on my melzi board from a few years ago…

    I’m assuming you flashed the board yourself, with your firmware? If the controller’s firmware was really messed up, it could be having an effect like this, but the processor on that board is the same as on any ramps or rambo.

    Maybe it’s noise affecting the serial lines from the controller to the lcd?

    I can’t see a good way this could be caused by the hardware of your controller board unless there was a missing component meant to reduce noise on those lines.

    #115112

    Jeffeb3
    Participant

    I just watched the video, clearly it’s got Ryan’s firmware on it. And it definitely looks like noise to me.

    #115113

    Tim
    Participant
    #115115

    frosty
    Participant

    Assuming pixels are loade line-by-line and left to right it looks like the clock line for the display is picking up extra transitions from noise which is shifting portions of the lines to the right. Could be as simple as a missing pull-up/down resistor on the CLK pin, but more data would be needed.

    You have an oscilloscope laying around by any chance?

    #115142

    David Walling
    Participant

    I had this issue with a bad LCD cable. Replaced the cables and the problem went away.

     

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.