Shifting the X-axis to E1 (Marlin firmware)

New Home Forum Milled Printed 3D Printer -MP3DP Advice – MP3DP Shifting the X-axis to E1 (Marlin firmware)

This topic contains 1 reply, has 2 voices, and was last updated by  Jeffeb3 2 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #105752

    Jethro
    Participant

    Actually nothing to do with the MP3DP.

    However, during tinkering with my MPCNC I fried the X-axis on my Ramps 1.4 shield, as I put the driver the wrong way in. The other 4 axis were still running.

    Is it possible to shift the X to E1, without tearing the whole firmware apart, so I could still use the board on my Ender 3, which has just 3-axis and 1 Extruder anyways. Eventually switching to TMC 2XXX.

    #105766

    Jeffeb3
    Participant

    You can just swap the pin assignments for X and E1 in pins_ramps.h.

    1 user thanked author for this post.
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.