August 24, 2016 at 5:44 pm #16657
Has anyone looked at the Shaper Origin? I don’t think it is worth as much as it costs to the average consumer, but to someone that needs portability it might be worth it. Basically there is a screen that shows the outline to follow and then you manually move the router around to “trace” the line on the screen but there are motors that move the router to compensate for inaccuracy in “tracing” the line by hand and lifts the router up.
https://shapertools.com/August 24, 2016 at 6:49 pm #16658
I have been watching videos about it today. Other than portability and space required I can’t see the advantage over a normal CNC. They say it’s better because you aren’t limited by the size but who wants to be standing there for an hour or two pushing it around when you could just be watching the machine do it for you. They are also talking like you just throw an SVG file on there and set your parameters on the screen. That would be easy if you are just cutting out pieces but what if you are doing something where you have different depths and some cuts outside the line and some inside? Are you doing all that on that little screen? Have you seen anything where they need more than one pass to cut out? Everything I have seen is in very thin material.August 25, 2016 at 5:52 am #16676
All fair points. I havent seen much about it. My only thought was that with my MPCNC I have to go pretty slow because the z axis is not as rigid as just holding the router right by the work piece. Pockets that take 10 minutes to cut out on my mpcnc take 2 to just hog out with the router by hand. But I am using old parts, a tall z axis, and some cracked parts that I couldn’t print replacements for over the summer.August 31, 2016 at 7:54 am #16933
We were all excited about it until the price ($1500 preorder $2000 retail) scared us away.August 31, 2016 at 8:03 am #16937
I wouldn’t blink an eye at the $2000 price tag if I had it to spend. I think it’s one of the best inventions I’ve seen in a while, possibly ever.
To just walk up to a piece of material and almost instantly cut out a perfect square or circle of any size with no setup.
I literally dreamed about this machine the night I saw it.
That being said, no, it does not take the place of a CNC router. Completely different in my mind.August 31, 2016 at 8:17 am #16945
It would make custom floor inlays much easier. Cut the design on your table CNC, then cut the pocket on the floor with this.August 31, 2016 at 8:20 am #16946
I saw it at the maker faire, It is pretty awesome. I just saw it on tested as well. They put a ton of time into R&D and even had to develop the machine to make the fiducial tape. They are the only ones with something like it so That price will probably hold for a long time, if not more if demand gets heavy. Pretty cool though.
You must be logged in to reply to this topic.