Right temperature settings ???

New Home Forum Milled Printed 3D Printer -MP3DP Advice – MP3DP Right temperature settings ???

This topic contains 0 replies, has 1 voice, and was last updated by  Jethro 2 months, 2 weeks ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #108203

    Jethro
    Participant

    Recently I had to set up my MP3DP from scratch. It went not to bad, because the people here rock. So in no time I was printing again, and this time everything seemed right.

    But after three days, I had parts they were very “fragile/brittle”, I checked those MP3DP parts I printed, and in fact a little force, and they broke too.

    So, what the heck was different from before. PLA, almost impossible it’s changing behavior within 2-3 days….so I checked all the movements are accurate, my first thought was I did something wrong with the extruder, no the extruder was accurate too.

    Make a long story short, I forgot to put the right value for the hotend thermistor, now everything is allright.

     

     

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.