Repetier Host GCode Not Working

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Repetier Host GCode Not Working

This topic contains 3 replies, has 3 voices, and was last updated by  Ryan 1 day, 10 hours ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #78422

    I’m having a strange error uploading gcode over cable using Repetier Host. I can move the CNC with the manual controls just fine, but when I run the crown g-code, it shows a bunch of “Unknown Command” errors. Why might this be occurring? Is it an issue with Marlin?

     

     

    #78426

    Barry
    Participant

    Is it Ryan’s gcode, or yours?  Can you post a screenshot of the errors?

    #78487

    Odd, I attached a screenshot in my post but I guess it didn’t work. It is Ryan’s gcode of the crown (I downloaded it directly from this website)

    #78507

    Ryan
    Keymaster

    The rest of that error file is more important, namely the first few lines. Also you need to give a lot more information. Board, computer, firmware, software. All you have told us is your stuff isn’t working the way you expect.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.