RC7 vs RC6 Y Direction

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 11 months, 2 weeks ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #29523

    Herman Meyer

    In troubleshooting something else, I flashed with the RC7 version of the firmware. I previously had the preloaded RC6. After the flash, my Y axis is inverted. I cut a simple word using the SD card and it needs a mirror to read it. I tried to control it with Repetier and it also ran backwards.

    Is there a setting I missed in Ramps? Did something change between the versions related to this?



    Power down and flip the y axis plug.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.