RC7 or RC8 for laser & t8 leadscrew?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC RC7 or RC8 for laser & t8 leadscrew?

This topic contains 2 replies, has 2 voices, and was last updated by  Paul Burnham 2 years ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #47659

    Paul Burnham
    Participant

    Hopefully a quick question here.  I’m also not on here a lot, so I apologize if this has been covered and I’ve missed it.  I’m currently running RC7 firmware on my machine that I use for 3D printing. (Pretty stock hardware setup from here). I am getting things around to add a 2.8W laser and I’m going to upgrade to the T8 leadscrew as I get a lot of Z banding that matches the thread on my 5/16″ all thread.  I’ve switched out all thread and made sure that it is true in the coupler, and not too tall of Z height.

    Anyway, I saw this : https://www.v1engineering.com/software-updates/

    and wondered if I should stick with the RC7 for printing and laser or update to RC8 for the T8 leadscrews as I can’t seem to find the default axis steps per unit in the RC7.  Also, any issues using RC8 for the laser?  TIA

    #47669

    Ryan
    Keymaster

    I would use the current firmware on this page. The steps are set for you and the laser is no problem.

    Firmware

    1 user thanked author for this post.
    #47676

    Paul Burnham
    Participant

    Awesome, thanks!

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.