Ramps stepper driver cooling fan voltage?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Ramps stepper driver cooling fan voltage?

This topic contains 2 replies, has 2 voices, and was last updated by  Stuart Smith 2 years, 7 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #25134

    Stuart Smith
    Participant

    I ordered the ramps pre-programmed board and printed a case for it which has a cooling fan hole for a 60mm fan. Is it 12 volts? And is it a 2 pin connector as well?

    #25137

    Barry
    Participant

    Yep, 2 pin 12vdc.

    #25191

    Stuart Smith
    Participant

    Thanks Barry

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.