Ramps Mega Control box

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Ramps Mega Control box

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 8 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #36179


    I have a MP Select Mini with a 120x120x120 print area. I want to print out a control box to house ramps/mega but I just can’t seem to find a small enough foot print. Any ideas? I can find a box and cut holes in it but I would rather print something out that’s sleek.



    The ramps with the lcd adapter is 118mm long so I am pretty sure most boxes will be a lot bigger than that. You could print mind just print the two pieces in half/two pieces and glue them together.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.