Solved Ramps dual endstop question

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Solved Ramps dual endstop question

This topic contains 3 replies, has 2 voices, and was last updated by  Randall Servidio 2 weeks, 2 days ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #119597

    Randall Servidio
    Participant

    New guy her with a Mega/Ramps trying to setup dual end stops.  I’ve downloaded the Marlin version shown here:

    https://github.com/Allted/Marlin/archive/MPCNC_Ramps_T8_16T_LCD_32step_DualEndstop.zip

    Everything compiles fine but the Axis isn’t defined like I would expect. I expected this: dual-stops
    But I’m getting this: Ramps
    Is there anything that needs to be changed besides uncommenting a display?

    #119601

    Jeffeb3
    Participant

    Why would you have two Z? Is tis for the low rider?

    You can change which axes are doubled in configuration_adv.h

    It’s easier to start where you are than to start fresh.

    #119605

    Randall Servidio
    Participant

    Sorry for being vague. Yes it’s for a Lowrider 2.  As I’m sure most know the Lowrider 2 has 1 x stepper, 2 y and 2 z.

    #119651

    Randall Servidio
    Participant

    After more digging my question was answered in the Lowrider section, I guess I should have posted there. To remap the drives I just had to uncommit dual x axis in advanced H, I was just afraid to mess something up by poking around. Hopefully the end stops will be as simple when I can get them wired up.

     

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.