Quad MPCNC – 4 MPCNCs stacked vertically

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC Quad MPCNC – 4 MPCNCs stacked vertically

This topic contains 6 replies, has 6 voices, and was last updated by  Andy 1 year, 3 months ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #60226

    James
    Participant

    I’ve just completed the first real milestone in my MPCNC-based printer array and I figured I’d show it off here in case anyone was considering doing something similar.

    Essentially it’s 4 MPCNCs all sharing a common frame made of aluminum extrusion. I drew up some clamps which hold the rails to the uprights. This eliminates the corner pieces and feet, though the rail spacing is still set by the spacers. Each gantry will have a print surface held by 20mmx20mm extrusions also mounted to the uprights.

    I clamped the rails on the inside of the extrusions so that the outside is free for enclosing side panels and access doors. Because I used 40mm x 40mm extrusion the roller assemblies have plenty of clearance between the rails and outer panels.

    Next step is my modified Z axis. In order to reduce the Z height I’m flipping the motor upside down and belting it to the lead screw. This should save at least 3 inches per machine, which ends up being substantial in this configuration. First prototype of this flipped Z has been printed and seems like it will work, now I just need to settle on a belt length. I can tell you 122mm isn’t enough for the motor to clear the Z bearings with 20t sprockets. 140mm should do it.

    I’m only shooting for 3 inches of travel per machine with a build envelope of around 20″ x 20″. This is plenty to make the parts I need with some margin for changes in the future. 

    1 user thanked author for this post.
    #60233

    Barry
    Participant

    That’s pretty cool.

    #60237

    Jeffeb3
    Participant

    Pretty slick. What are you making? Looks big and flat, which is perfect for this beast. Have you looked at the steppers with an integrated leadscrew? That would at least remove the coupler.

    #60240

    Ryan
    Keymaster

    I can’t wait to see this in action.

    #60241

    James
    Participant

    Pretty slick. What are you making? Looks big and flat, which is perfect for this beast. Have you looked at the steppers with an integrated leadscrew? That would at least remove the coupler.

    I’m making battery “cores” which hold ~300 18650 cells. Along with a rugged handle they will contain a BMS board that monitors voltage and temperature. After being populated they get spot welded with nickel strip and quick-disconnect high current connectors. Then everything gets encased in epoxy for water and vibration proofing.

    Similar to these smaller battery modules I’ve made.

    Attachments:
    1 user thanked author for this post.
    #60351

    Dui, ni shuo de dui
    Participant

    That’s badass stuff!

     

    #63862

    Andy
    Participant

    are you going to use a layer of the mpcnc as a spot welder too?

    I can see this is probably easier to get square than the original too. Great use of space.

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.