Problem with Estlcam going through islands

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Problem with Estlcam going through islands

This topic contains 1 reply, has 2 voices, and was last updated by  Christian Knuell 4 days, 21 hours ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #103251

    duncan999007
    Participant

    This is more of a problem with just Estlcam, but since support is nonexistent and most of us seem to use it, I figured I’d ask and see if I’m missing something.

     

    I have a part cut containing a pocket with islands. All cuts well until one of the perimeter passes where the router just plunges down and mills right through the top right island, seemingly for no reason. It could easily just move over to that perimeter and plunge there, but it doesn’t.

    I can’t find a way to correct this without manually finding and editing that part of the gcode, is there another way here?

    Screenshot-3

    Screenshot-4

    • This topic was modified 5 days, 3 hours ago by  duncan999007.
    #103270

    Christian Knuell
    Participant

    Hello,

    please send the affected project file to [email protected] – I’ll have a look at it (but may unfortunately take a while).

     

    Thanks

    Christian

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.