Printer and Slicing settings

New Home Forum Mostly Printed CNC – MPCNC Troubleshooting – MPCNC Printer and Slicing settings

This topic contains 3 replies, has 4 voices, and was last updated by  Ryan 3 years, 12 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
  • #2088


    I want to collect different settings to help new CNC users and to avoid waste of time and filament.

    These are my settings:

    • Vellemann K8200 Printer with heated bed
    • 0.5mm nozzle (0.0196″)
    • Cura settings:
      • layer height: 0,25mm
      • speed: 53mm/s, outer perimeters: 50mm/s, infill: 86mm/s
      • hull thickness: 0.8mm, top/bottom thickness: 0,6mm
      • overlap 15%
      • infill: automatic, 50%
      • solid top and solid bottom enabled
      • using 5mm brim, no support or raft needed at all
    • printing on heated bed (60°C) with capton tape, works very good and parts can be easily removed when bed is cold again

    Please post your settings and experiences too!



    Here are my settings:

    Soliddoodle 2 Pro

    0.4mm nozzle
    Cura settings:
    0.2mm layer layer height
    40% infill
    bottom and top 3 layers solid
    0 brim, 0 support, 0 raft
    bed heated to 70C, nozzle at 112C
    All parts printed with PLA.



    All the parts at 50% infill?



    I hope not,


Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.