Possible to remix MPCNC files for 12mm rod?

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Possible to remix MPCNC files for 12mm rod?

This topic contains 2 replies, has 2 voices, and was last updated by  Stu H 1 month, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #111324

    Stu H
    Participant

    So I picked up one of these https://www.3dbeginners.com/cubepro-3d-printer-review/   for FREEEE…

    Anyways, I love the enclosure and the hardware is very robust so I got thinking, rather than building another 3dprinter, could I adapt the MPCNC files (namely the gantry pieces) into something meant for 12mm solid rod, versus the hollow conduit?  I’m not a wiz with fusion360 or anything but if it was possible I could eventually get there (maybe)

    Anyways–thoughts?

    #111404

    Aaron
    Participant

    I would check thingiverse. I’ve seen an mpcnc small remix using rod as well, but don’t remember if it was 12mm

    1 user thanked author for this post.
    #111508

    Stu H
    Participant

    Thanks for tip–I have scanned thingiverse in the past but wasn’t really looking in the right places i guess..

    I cam across this one https://www.thingiverse.com/thing:1860521  so I’ll see if I can modify the parts I have to fit.  The cubepro comes with some nice linear bearings that I would like to re-use…

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.