September 23, 2018 at 5:00 pm #70128
1- Pictures. 99% of the time A few pictures of your entire build will help, including electronics. We do not care about empty pizza boxes and nasty wiring. Seriously if you do not get any further….show some pictures.
2- Link it. If you are using something you did not buy from here, link it. We don’t care where you choose to spend your money. We only care about getting you going as smoothly as possible. Saying “I bought the recommend part” 100% does not help.
3- Software. This leaves software. Run my crown Gcode. Did it work perfectly with a pen? Yes=continue….No=send pictures and links. The crown should be perfect if not it is pointless to move on. If that is good details of all the software you are using (too many times we get ten questions in and find out I am talking Estlcam and they are using something else). Screen shots help, dropbox or drive links to your files and gcode help.
4- New. Start a New thread. Even if you think you are having the exact same issue, please start a new thread.January 31, 2019 at 10:07 am #86718
luis carlos de souzaParticipant
SOCORRO help me please, I did everything until my mpcnc is ready so that now at the end I came across a problem the straps, if I tighten the motor does not walk to walk the straps have to be all loose, she without the belts slip super Well, when I put on the belts, it’s all wrong, she does not walk or when she hangs at a certain point, you could give me this light, thank you.
Attachments:January 31, 2019 at 12:12 pm #86740
Ryan will probably move this to it’s own thread. (And edit this line out)
You do not have power connected to your shield. Without power there the motors will not turn.
No tienes energía conectada a tu escudo. Sin potencia allí los motores no girarán.
You must be logged in to reply to this topic.