October 24, 2019 at 1:08 pm #118890
Cheap enough to pull the trigger on, though I’ve been burned a few times in the past on KS. It’s a bit more of a hassle to use due to the post-print procedure (bathe in alcohol, dry and then UV time) but it looks like it’s doing a good job (this one just used the default settings).
Attachments:October 24, 2019 at 1:12 pm #118893
That is one sharp looking benchy.October 24, 2019 at 4:05 pm #118902
Oh man, I want one…for I’m not sure but I want one!
Someone else here has one…..Can’t wait to see what you both make with them.October 24, 2019 at 6:51 pm #118908
Dui, ni shuo de duiParticipant
That’s a super clean result. How long did it take to print?October 24, 2019 at 8:14 pm #118910
Marion J. MakarewiczParticipant
Now I am being tempted by you guys on this forum! I spend most of my time hanging out at the Glowforge laser forum. Someone posted that they got an Elegoo Mars which pops up incredibly inexpensive at times. Next thing you know, about ten other people have bought them, including some for whom it is their first 3D printer.
I’m holding out for Christmas, although I did watch a few Moai Phenom videos in the past couple days and am sorely tempted.October 25, 2019 at 12:11 am #118914
That’s a fine looking benchyOctober 25, 2019 at 4:44 am #118928
I wish resin printers didn’t use resin.October 25, 2019 at 6:16 am #118934
I got my Anycubic Photon for around $300 on ebay (they are listed for more, but I sent an offer of $300 and I think they countered with $350 and I countered with $310 and they accepted it) from the manufacturer listing.
I don’t ever use it because it’s such a mess. Buuuut at the same time I don’t want to get rid of it, because like… what if I need it one day??
I can’t say I’d recommend a casual user getting one. You have to really want it to deal with the cleaning, curing, manual supports, possible health implications of the resin, etc.October 26, 2019 at 7:22 am #119025
BarryParticipantOctober 26, 2019 at 7:24 am #119029
BarryParticipantOctober 27, 2019 at 2:03 pm #119125
Yeah, Beam3D. I’m going to try and print an enclosure for the SKR Pro v1.1 that I want to put on my original MP3DP. I may have to jigsaw puzzle it a bit to fit the print area though. 🙂
You must be logged in to reply to this topic.