Painting the frame ??

New Home Forum Milled Printed 3D Printer -MP3DP Advice – MP3DP Painting the frame ??

This topic contains 3 replies, has 4 voices, and was last updated by  Jeffeb3 2 months, 3 weeks ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #107479

    Jethro
    Participant

    I finally finished the frame parts for the MP3DP, in 12mm multiplex.
    I see that many builds did paint their frame, has that any other reasons than esthetics?
    For me it would look good enough like it is, eventually some teak oil, as I have still plenty around?

    #107511

    Ryan
    Keymaster

    Teak oil would really make those parts nice! My opinion, Show off the wood!

    1 user thanked author for this post.
    #107529

    Bill
    Participant

    Yeah, the grain is too pretty to paint it.

    1 user thanked author for this post.
    #107538

    Jeffeb3
    Participant

    Some kibd of finish really helps. It drives faster, attracts women, and when you clean up after a failed print, it will promise to be better next time.

Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.