- February 25, 2017 at 6:27 am #28395
I need to replace a few Parts from the older build about a year ago. Does anyone have the link for the parts files? I have a cracked motor mount.
Thank youFebruary 25, 2017 at 8:42 am #28401
I didn’t know there were older parts for the printer?February 25, 2017 at 8:53 am #28405
Moved it to MPCNC.
Rand what parts do you need? I really can’t put them all up here, but I can do a few.February 25, 2017 at 10:26 am #28411
I need the file for the motor mount with 7 bearings for the conduit rail. Do you still have a copy of the older list? I would like to get a copy to replace parts if they fail over the years.
Attachments:February 25, 2017 at 10:34 am #28413
I think these are what you are looking for.
https://www.youmagine.com/designs/mostly-printed-cncFebruary 25, 2017 at 10:37 am #28414
The ones I purchased over a year ago are very different then the files that are there now. The motor mount also looks different and combines two parts.February 25, 2017 at 10:46 am #28415
Fantastic Ryan – these are exactly what I wanted. As usual you had it at your fingertips. Thank you.
Is this a different site for storing projects or public domain? I will download a set so I can replace parts without bothering you…. for curiosity – why was my post sent to MPCNC? I am using it as a 3D printer. Is this the wrong forum?February 25, 2017 at 11:16 am #28419
I don’t plan on getting rid of the youmagine files, it is a thingiverse competitor, but the traffic is very low there and the editing is too hard so I just use thingiverse.
Even though you are printing it is still with the mpcnc, I have a printer design as well, the milled printed 3D printer or MP3DP.February 25, 2017 at 12:37 pm #28425
I have been printing 20mm test cubes to work on learning cause and effect of temp and flow settings. My finish has detoriated over the past weeks and don’t know where to start. The biggest problem I have recently is the test cube prints slanted left to right. I have checked for squareness and the Z axis. What’s odd is if I swap the X and Y stepper wires and run samples both ways I get the exact same slant. I would assume this rules out the software but I can’t find anything mechanical. What would a weak driver look like?
Attachments:February 25, 2017 at 12:39 pm #28427
Attachments:February 25, 2017 at 12:44 pm #28430
A bad stepper would cause very clear stair steps.
That seems like a non perpendicular z axis. Try a carpenter’s square or something on the table and rotate it around the z tubes as much as possible. I would guess it is tilted. Meaning a tension imbalance between the top and bottom mount bearings for that axis.
When you get that figured out I would test prints with something a bit bigger, small prints kind of have other issues that larger normal sized prints don’t.
You must be logged in to reply to this topic.