Old part request

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 11 months, 1 week ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #29645


    I need to reprint a couple of the part that holds the pipes down for X / Y in my MPCNC… but, I can’t find them. it was a flat-ish part using leverage and 2 screws to hold in place.

    also… are the new rollers enough better to bite that off instead of just reprinting the piece that’s broke?




    Yes the new rollers pretty much eliminate the motor mount flex, much more rigid.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.