Nut Lock

This topic contains 2 replies, has 2 voices, and was last updated by  David 1 year ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #26453


    Printing out all the parts so I can build my MPCNC. Under the parts page for nut lock it shows 1, however then it shows 1:15 printed part and 2:30 total time which would indicate 2. So is it 1 or 2?



    This is the most common question I get, no joke.

    The parts kit comes with both, so the print time is quoted for both. That way I can figure out how much I charge per hour of print time for replacement parts.



    Sounds good, I appreciate all the hard work you have put into this. I’ve been on and off printing the parts for the past 2 months but trying to marathon print to the end.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.