New MPCNC 500x700mm

This topic contains 2 replies, has 2 voices, and was last updated by  Odacir Cristofolini 1 year ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
  • #26599


    I’m building a MPCNC, with printed parts in ABS and conduit, with 25mm OD and 1,9mm of wall tickness.

    I like a work area about 500x700mm and Z 60mm. With this area, its possible work with aluminium, or is a large area to try aluminium?
    If recommend a smaller, i will change my project. Its important to me, work with aluminium too.

    I made a Google Photos Album with all photos of printed parts. I will update here the post, with the steps of the construction.

    The link:

    Thanks a lot for this project!!! 🙂


    Martin DB

    Z is very good with 60mm for aluminum. Sides may be, but if you mill in the corner, I think you will be ok.
    Barry mills aluminum with a bigger mpcnc really well.


    Thanks Martin.

    I will go ahead!!! 😀

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.