New MPCNC Build, Israel

New Home Forum Mostly Printed CNC – MPCNC Your Builds – MPCNC New MPCNC Build, Israel

This topic contains 3 replies, has 2 voices, and was last updated by  Kamil 1 week, 3 days ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #117059

    Kamil
    Participant

    Hello,

    Finally my parts arrived and I can start building my MPCNC

    Attributes:

    • Work area 636mm x 336mm
    • Outer dimensions (tubes) 900mm x 600mm
    • 500W 3 Phase spindle from Bangood
    • Marbel PLA, and Hatchbox silk

    Base stage – Done

     

    1 user thanked author for this post.
    #117171

    Ryan
    Keymaster

    Cool color scheme, can’t wait to see it finished.

    Welcome!

    #117174

    Kamil
    Participant

    Thank you Ryan.

    I would like also to thank you on a beautiful design, i worked on it today for about 8 hours.

    I initially wanted to use only the marble PLA, but due to failed prints i ran out 🙁

    I finished the assemble and will start with the wiring. hopefully in a couple of days. I will take this time to print drag chain for the wires.

    I attached a marker to the Z-Assemple and moved it around by hand to draw the “work area”. As you can see the square seems to be very good 🙂  the dimensions are 335mm and 625mm almost as planned.

    I just hit a small road bump and it was that i broke my XYZ Plate when tried to tighten the outer screws, re-printed and all is good

    • This reply was modified 1 week, 4 days ago by  Kamil.
    1 user thanked author for this post.
    #117310

    Kamil
    Participant

    I setup the belts and electronics and ran my first crown test 🙂

    My build

    My crown test

     

    • This reply was modified 1 week, 3 days ago by  Kamil.
    1 user thanked author for this post.
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.