New Build Sewell NJ

This topic contains 5 replies, has 4 voices, and was last updated by  Jason 2 months, 1 week ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #95187

    Ron Gibson
    Participant

    Waiting on 1″ Tube and Electronics

    #95363

    Steve
    Participant

    Welcome, Looking good..

    1 user thanked author for this post.
    #95457

    Ron Gibson
    Participant

    Getting better!!!  Steppers arrive today!!!

    #95501

    Ryan
    Keymaster

    Closer….

    1 user thanked author for this post.
    #95639

    Ron Gibson
    Participant

    Installed Steppers and the Brains should be here tomorrow.  Thanks for the fast shipping Ryan.  The X and Y are movable by hand the Z is a little tight, however I can rotate the rod and the carriage does move.  Will the 80 oz steppers I got overcome a slight drag of the bearings.

    #95804

    Jason
    Participant

    I was worried about how tight the z was on my machine but after I ran it up and down a few times everything feels a lot smoother I also use 84oz motors so you should be fine

    2 users thanked author for this post.
Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.