Need Clarification on RAMBo Boards

New Home Forum Mostly Printed CNC – MPCNC Advice – MPCNC Need Clarification on RAMBo Boards

This topic contains 1 reply, has 2 voices, and was last updated by  Ryan 1 week, 3 days ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #99749

    Kevin
    Participant

    Hello,

    I’m very excited to start building my MPCNC, but I need a little clarification on the boards. I plan on starting off simple with a 24″ x 24″ x 4″, with no endstops, but I also want the ability to upgraded my MPCNC to use enstops without having to buy another board. From my understanding, I would have to get the RAMBo Dual Firmware & Wire Kit. If I do get this board, do I have to wire up the endstops initially, or can I leave them off until I’m more familiar with my machine?

    Thanks.

    #99750

    Ryan
    Keymaster

    Get the series kit, and either add the individual wire kit or buy them later. That way the board is flashed correctly and you will be ready to run ASAP. The dual kit would need firmware edits to work with no end stops.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.