September 4, 2018 at 8:38 am #68334
I can find cases that combine the RAMPS and LCD but none for the RAMBO 1.4 and LCD – can anyone point me in the right direction? ThanksSeptember 4, 2018 at 9:20 am #68347
I keep mine separate. I like to be able to move the LCD for various reasons.September 5, 2018 at 6:41 pm #68495
Do you like this? I combined an LCD case (thingiverse) and made my own RAMBO case. You’ll need a good size printer for the case. The design is public in onshape. Just search rambo caseSeptember 12, 2018 at 10:57 am #69000
I’m currently printing the following:
The big part should be done tomorrow morning. If it looks ok and the RAMPS+Mega boards fit in it, then I’ll print the front/sides/etc for it.September 13, 2018 at 6:07 am #69094
Svein Inge KallevikParticipantSeptember 16, 2018 at 1:57 pm #69495
Does the ramps and RAMBO board fit the same form? A lot have posted about ramps and not RAMBO 1.4September 16, 2018 at 2:03 pm #69497
NopeFebruary 9, 2019 at 7:36 am #88318
Still looking for enclosure options for full size Rambo and LCD (or just the Rambo board).
I’m running into the same problem. Perhaps I’m not looking in the right place, but there are tons of ramps and mini Rambo cases on Thingiverse and in this forum, but very few full size Rambo cases with LCD.February 23, 2019 at 7:50 pm #90548
MikeKParticipantFebruary 24, 2019 at 9:38 am #90615
Nice, I like it!May 3, 2019 at 10:15 pm #99236
I was in the same boat trying to find a case but I wasn’t finding the perfect one. I decided instead to make one out of a couple different things I found on Thingiverse. I am still working on the Rambo case but the prototype for the smart LCD is done. In my design the monitor is mounted on a swivel above the corner of the machine. It keeps it very stable and in a good spot for use while not being in the path of the machine. Additionally if I need to access the machine from the front or side I can turn the monitor accordingly. I can probably post this to thingiverse once it’s all done if anyone is interested.
1 user thanked author for this post.
You must be logged in to reply to this topic.