Need a DFX file created

This topic contains 5 replies, has 5 voices, and was last updated by  Marcus 1 month, 4 weeks ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #72106

    Jason Dewester
    Participant

    Any carbide create gurus that could make the attached file into a dfx? shoot me a message what you would charge to create the file.

     

    Thanks

    Jason Dewester

    #72119

    Jeffeb3
    Participant

    How about an svg? Converting images (even PDFs) to svgs is easy with inkscape. I opened it in estlcam just to be sure.

    You’ll have to scale it.

    #72138

    BillW
    Participant

    Is this any good for you Jason, it is drawn in metric.

    Rename the file extension to dxf

    Attachments:
    1. Soap-dish.txt
    #72190

    Jason Dewester
    Participant

    Thanks guys for the help I just need to figure out how to scale it to size in estlcam.

    #72195

    Barry
    Participant

    In estlcam, View, Grid, X 25.4 Y 25.4 .  This gives you a grid of 1 inch squares.  Now you can scale up or down to the squares.  You can also hold the middle mouse button on an edge line and draw a measurement line to the other side, have to keep holding, or it goes away, but a quick way to check.

    #97551

    Marcus
    Participant

    Hi Jason,  did you fix that ?  As i understand you right  you need a dxf  file  use in estlecam.

    If you like i can make that for you, just for fun.   I like this pojekts to build it in fusion 360.

    If you like – give me a message and i will do it.

    Best regards

     

    Marcus

    p.s. I use also Estlcam and the MPCNC

     

     

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.